IBM System x iDataPlex dx340, Руководство по диагностике и обслуживанию

Страница: 122 / 196

Removing a memory module
To remove a DIMM, complete the following steps.
Retaining
clip
DIMM
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 71.
2. If the system-board tray is installed in a chassis, remove it (see “Removing the
system-board tray from a 2U chassis” on page 75 or “Removing the
system-board tray from a 3U chassis” on page 77).
3. If an expansion enclosure is installed, remove it (see “Removing an expansion
enclosure from a system-board tray” on page 73); otherwise, remove the
system-board tray cover (see “Removing the system-board tray cover” on page
121).
4. Locate the DIMM connectors (see “System-board connectors” on page 7).
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
5. Press the DIMM retaining clips to the open position.
6. Lift the DIMM out of the DIMM connector.
7. If you are instructed to return the DIMM, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
106
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide