Installing a 3.5-inch simple-swap hard disk drive
To install a 3.5-inch simple-swap hard disk drive, complete the following steps.
1. Touch the static-protective package that contains the hard disk drive to any
unpainted
metal surface on the outside of the chassis or rack; then, remove the
hard disk drive from the package.
Attention:
Do not press on the top of the drive. Pressing the top might
damage the drive.
2. Align the drive with the guide rails in the drive bay.
3. Pull the loops of the drive toward each other; then, carefully slide the drive into
the bay until it stops, and release the loops.
Note:
Do not release the loops on the drive until it is completely seated.
4. Install the filler panel in the drive bay.
5. Turn on the system-board tray (see “Turning on the system-board tray” on page
Chapter 4. Removing and replacing server components
91
Содержание System x iDataPlex dx340
