IBM System Storage TS2900, Руководство по установке, эксплуатации и обслуживанию

Страница: 150 / 257

8-2
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Figure 8-1. Cartridge magazine lock release access hole
2. Insert the end of a straightened paper clip, or similar object, into the lock release
access hole and gently push the lock mechanism to release the lock and eject the
cartridge magazine.
3. If the I/O Station is enabled, push the lock mechanism twice or push and hold
the lock mechanism until the cartridge has been withdrawn far enough to clear
the I/O Station lock.
4. Remove the cartridge magazine from the front of the library. If the magazine is
stuck in the library and does not eject, see “Contacting IBM Technical Support”
on page 7-1.
5. Examine the magazine and cartridges for damage.
• If there is damage to a cartridge, replace that cartridge.
• If there is damage to the magazine, replace the magazine.
Moving the Library from a Rack to a Desktop
This procedure is used to relocate a library mounted in a rack using the rack mount
kit to a desktop using the deskside kit.
Removing Library from a Rack
1. Take the library offline.
Note: If the library is processing queued requests, wait for the library to finish
the current library task.
2. From the Web User Interface, select Configure Library
→
Save/Restore
→
Save
to save the current library configuration to a file for easy restoration.
3. After saving your configuration, log out of the Web User Interface and close the
Internet browser.
4. From the Operator Panel, select Unlock Magazine , and press Enter to remove the
cartridge magazine (if necessary).
Note: If the cartridge magazine fails to unlock in response to the Unlock
Magazine command from the Operator Panel, you can unlock the
magazine manually. See “Unlocking the Cartridge Magazine Manually”
on page 8-1.
5. From the Operator Panel, select Move to Ship Position , and press Enter. This
moves the Accessor assembly to a safe position ready for moving the library.
Note: If the library is to be transported any distance, this move is necessary to
park the Accessor in the position where it can be secured by the Accessor
locking screw.
1
a29z0027