IBM System Cluster 1350, Установка и обслуживание

Страница: 111 / 170

Chapter 16. Cisco 10/100 Switch replacement and
configuration
Contents
Replacement of the 24-port switch
To replace the Cisco 24-port 10/100 Switch, you must remove the rails from the
cabinet.
Remove the rails from the cabinet
1. Remove the mounting screws from the front vertical cabinet rails and remove
the cover bracket.
2. Remove the mounting screws from the rear vertical cabinet rails.
3. Slide the rails out the rear of the cabinet.
Remove the Cisco 24-port 10/100 Switch from the rails
Unscrew the Cisco 10/100 Switch from the rails. There are four holes on each side
of the devices.
Install the Cisco 24-port 10/100 Switch and rails
1.
Mount the switch rails to the Cisco 24-Port 10/100 Switch. Mount the rails so
the Cable Management Tab is on the left rail, as shown in the figure below. Use
four screws on each side. Use the set of two large holes at the front of the rail
and the set of two large holes that are the third set from the back of the rail.
© Copyright IBM Corp. 2003
93