IBM Storwize V7000, Руководство по обслуживанию

Страница: 115 / 172

4.
Pull out the drive.
5. Push the new drive back into the slot until the handle starts to move.
6.
Finish inserting the drive by closing the handle until the locking catch clicks
into place.
Replacing an enclosure end cap
This topic describes how to replace an enclosure end cap.
To replace the enclosure end cap, perform the following steps:
1. On either side of the drive assemblies, remove the enclosure end caps by
squeezing the middle of the cap and pulling it away from the front of the rack.
2.
Reattach the end cap by relocating it on either side of the drive assemblies and
gently pushing it on.
Replacing a SAS cable
This topic describes how to replace a SAS cable.
Be careful when you are replacing the hardware components that are located in the
back of the system that you do not inadvertently disturb or remove any cables that
you are not instructed to remove.
To replace a SAS cable, perform the following steps:
1. Record which SAS cable is plugged into the specific port of the expansion
canister. The cable must be inserted back into the same port after the
replacement is complete; otherwise, the system cannot function properly.
Note: If you are replacing a single cable, this step is not necessary.
svc00615
Figure 37. Removing the 2.5" drive
Chapter 8. Removing and replacing parts
99