IBM Slicestor 2584, Руководство по установке, Страница: 19 / 42

Chapter 2. Preparation
Before you install the system, verify the location and installable components.
Before you begin
Before you begin installing the product, you must meet certain requirements.
Make sure that the site where you intend to set up and use your storage system can meet the following
needs:
v
Standard power from an independent source or a rack power distribution unit with a UPS.
v Host computer with the correct firmware, BIOS and drivers. Contact your supplier for the correct
software levels.
Before setting up your enclosure, ensure that you have the following accessories:
v Power Cord
v Rack kit (if installing within a rack)
Refer to your supplier for a list of qualified accessories for use with the enclosure. The accessory box
contains the power cords and other ordered accessories
Unpacking the storage system
Read these instructions before unpacking the system.
1.
Position the shipping case within 2m (6 feet) of the site where you intend to use your storage system.
2. Inspect the packaging for crushes, cuts, water damage or any other evidence of mishandling during
transit. If there is any damage, photograph the packaging for future reference before opening.
3. Unpack the system, as shown in the following figure.
© Copyright IBM Corp. 2016, 2018
5