IBM SCM, Руководство пользователя

Страница: 27 / 54

b. Inspect the LGA socket for bent or broken pins or debris, using the Magnifying Glass (P/N
11P4747) as needed.
c.
Remove any debris from the LGA socket using the Air Pump (P/N 45D2645). Do not blow on the
LGA site with your mouth.
d. Take the cover off the CP module carrier tray containing the replacement module.
e. Attention : Be careful when opening the CP module carrier tray.
f. Ensure the (A01) corner of the replacement module lines up with the triangle of the CP module
carrier tray.
g. Ensure that the CP SCM module insertion tool latches are open.
h. Place the CP SCM insertion tool over the module while ensuring that the (A01) corner is aligned
with the (A01) label on the load frame, carefully close the latch by pressing the center pushbutton
down and release the two latches. Make sure the two "wings" on the pushbutton are at about the
same level as the latches.
i. Lightly push down on the CP SCM insertion tool to allow the latches to close.
j.
Slowly lift the CP SCM insertion tool and CP SCM module straight up and out of the CP module
carrier tray by holding on to the ring if the SCM tool has a ring, otherwise grasp the sides of the
tool.
k. Turn the SCM tool over to ensure that the jaws are firmly grasping the SCM.
Note: If one of the jaws is not firmly grasping the SCM, press down on the corner of the SCM
closest to the jaw until it locks into place. Do not touch any part of the SCM other than the
corners.
l. Lower the tool and SCM onto the socket, ensuring the guide pins (B) are inserted into the
alignment holes.
Note: DO NOT attempt to slide the tool and the SCM in any direction while the SCM is
touching the socket.
If the tool/SCM is not aligned with the guide pins (B), lift the tool/SCM and
reposition them.
Install SCM
23