IBM SAN512B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 97 / 286

The following table describes the extension blade LED patterns and the
recommended actions for those patterns.
Table 11. Extension blade LED descriptions
LED purpose Color Status Recommended action
Power
Steady green Blade is operational. No action required.
No light (LED is off) Blade is not powered on. Ensure that the blade is
firmly seated, with ejectors
pushed in fully to center of
blade and captive screw for
each ejector fully tightened.
Status
No light (LED is off) Blade is either healthy or
does not have power. Verify that the power LED
is on.
Steady amber Blade is faulty or
initializing. Ensure that the blade is
firmly seated and check the
status by entering the
slotShow command. If LED
remains amber, consult the
device supplier.
Blinking amber and green. Attention. Blade is not
seated correctly or is faulty. Pull the blade out and
reseat it. If LED continues
to flash, replace the blade.
Green Blade is operational. No action required.
GbE port status
No light (LED is off) Port has no incoming
power, or is offline. Verify that the power LED
is on, check the transceiver
and cable.
Steady green Port is online but has no
traffic. No action required.
Blinking green Port is online, with traffic
flowing through port. No action required.
Steady amber Transceiver or port has
error or is faulty. Change the transceiver or
reset the switch from the
workstation.
Chapter 6. Monitoring the switch
73