IBM SAN42B-R, Инструкция по установке, обслуживанию и эксплуатации

Страница: 51 / 96

Table 5. tsTimeZone command parameter selection (continued)
Local time
tsTimeZone parameter (difference from
UTC)
Alaskan Daylight -8,0
Hawaiian Standard -10,0
FCIP and Fibre Channel routing services configuration
The ports on the switch are initially set to persistently disabled.
If you want to enable the FC ports as a standard E_Port or F_Port, use the
portcfgpersistentenable
command to enable the ports.
If you are using the FC ports as EX_Ports, you must configure the Fibre Channel
Routing Services feature before enabling the ports.
Refer to the Fabric OS Administrator's Guide for detailed instructions on configuring
the Fibre Channel router ports and GbE ports on the switch.
Installing SFP+ and QSFP transceivers and connecting cables
Complete the following steps to install SFP+ transceivers and to connect cables to
the switch. The process for installing QSFP transceivers is similar. The transceivers
may already be installed in the switch as shipped. If this is the case, you can either
just proceed to attaching the cables, or remove each transceiver, attach the cable,
and then reinstall each transceiver and cable as one unit.
Attention: Use only transceivers that are supported for this product. Only
transceivers purchased from IBM are supported. The use of transceivers that are
not supported may cause data loss or cause the product to malfunction. For a
listing of transceivers compatible with this product:
v
Go to the IBM Support Portal www.ibm.com/supportportal.
v
In the Search support field, enter
b-type supported transceiver
and then press
Enter . Click the link on the page that displays.
v
Alternatively, use this direct link: http://www-01.ibm.com/support/
docview.wss?uid=ssg1S1004421.
If you use an unqualified transceiver, the switchShow command output shows the
port in a Mod_Inv state. Fabric OS also logs the issue in the system error log.
The 16 Gbps SFP+ transceivers have an attached pull tab and no latching wire bail.
To simplify insertion of the 16 Gbps SFP+ transceivers, IBM recommends
connecting the cables first, and then inserting them as a unit into the port.
Figure 18 on page 29 shows the installation of a 16 Gbps SFP+. All SFP+
transceivers are keyed so that they can only be inserted into the ports in the correct
orientation. Transceivers should slide easily into the port if aligned correctly.
Chapter 2. Installing and configuring the switch
27