IBM SAN384B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 74 / 190

The 64-bit chassis ID is required to obtain and activate licenses for the SAN384B-2.
The chassis ID is available through the
licenseIdShow command.
The licenseShow and licenseIdShow commands must be entered on the active CP
blade.
Refer to the Fabric OS Administrator's Guide for more information.
Installing transceivers and attaching cables
The following two sets of steps cover the installation of transceivers and cables for
most SFPs and for QSFPs.
Note: For a listing of transceivers compatible with this product:
v
Go to the IBM SAN web page www.ibm.com/systems/storage/san
v Select the IBM System Storage SAN768B-2 and SAN384B-2 product link
v
On the displayed product page, click the Interoperability Matrix link in
the Learn more section.
v In the Interoperability matrix, click the Transceivers link.
Follow the first set of steps to install SFP+s and mSFPs (FC8-64 port card only) and
cables to the SAN384B-2 (see “Removing and installing transceivers” on page 89
for more details). Follow the second set of steps to install the QSFP transceivers
and cables in the core blades for inter-chassis link connections (see “Removing and
replacing inter-chassis link (QSFP) cables” on page 93 for more details).
Attention: mSFP transceivers are compatible only with the FC8-64 port blade.
While they will fit in other blades, this configuration is unsupported and will
generate an error.
The ports are color-coded to indicate which can be used in the same port group for
trunking (trunking port groups can be up to eight ports). The ports and cables
used in trunking groups must meet specific requirements. Refer to the
Fabric OS
Administrator’s Guide for more information.
Follow these steps to add the optical transceivers and cables to the Fibre Channel
ports.
1.
Position one of the optical transceivers so that the key is oriented correctly to
the port. Insert the transceiver into the port until it is firmly seated and the
latching mechanism clicks.
Transceivers are keyed so that they can only be inserted with the correct
orientation. If a transceiver does not slide in easily, ensure that it is correctly
oriented.
2. Position a cable so that the key (the ridge on one side of the cable connector) is
aligned with the slot in the transceiver; then, insert the cable into the
transceiver until the latching mechanism clicks.
Cables are keyed so that they can only be inserted with the correct orientation.
If a cable does not slide in easily, ensure that it is correctly oriented.
3. Repeat steps 1 and 2 for the remaining ports.
4.
Organize the cables as required. For recommendations regarding cable
management, refer to “Managing cables” on page 44.
5. Verify the chassis and port status using the switchShow command.
6. Verify fabric connectivity using the fabricShow command.
42
SAN384B-2 Installation, Service, and User Guide