IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 85 / 292

v A serial console connection to the active CP blade. The active CP is indicated by an illuminated
blue LED on the blade front panel.
v
A Telnet session using the chassis management IP address.
2. Log into the device using admin. If you have not changed the default password, usepassword.
3. Enter the
date
command, using the following syntax:
date "mmddHHMMyy"
The values are:
v mm is the month; valid values are 01 through 12.
v dd is the date; valid values are 01 through 31.
v HH is the hour; valid values are 00 through 23.
v MM is minutes; valid values are 00 through 59.
v yy is the year; valid values are 00 through 99 (values greater than 69 are interpreted as 1970
through 1999, and values less than 70 are interpreted as 2000 through 2069).
switch:admin> date
Fri Sep 28 17:01:48 UTC 2016
switch:admin> date "0927123016"
Thu Sep 27 12:30:00 UTC 2016
switch:admin>
Setting the time zone
About this task
The default time zone is Coordinated Universal Time (UTC). The time zone needs to be set only once
because the value is stored in nonvolatile memory. Use the following procedure to set the time zone. The
time zone change will take affect after the next system reboot.
Procedure
1. Log into the device using one of the following methods:
v A serial console connection to the active CP blade. The active CP is indicated by an illuminated
blue LED on the blade front panel.
v A Telnet session using the chassis management IP address.
2. Log into the device using admin. If you have not changed the default password, use password.
3. Use one of the following steps for the tsTimeZone command.
v Enter tsTimeZone --interactive command, enter the appropriate number as shown in the
following example, then follow prompts.
sw0:admin> tstimezone --interactive
Please identify a location so that time zone rules can be set correctly.
Please select a continent or ocean.
1) Africa
2) Americas
3) Antarctica
4) Arctic Ocean
5) Asia
6) Atlantic Ocean
7) Australia
8) Europe
9) Indian Ocean
10) Pacific Ocean
11) none - I want to specify the time zone using the POSIX TZ format.
Enter number or control-D to quit ?
v Enter tsTimeZone [houroffset [, minuteoffset]] command as follows:
– For Pacific Standard Time, enter
tsTimeZone -8,0
.
– For Central Standard Time, enter tsTimeZone -6,0 .
Initial Setup and Verification
57