IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 81 / 292

Establishing a serial connection to the device
About this task
To establish a serial connection to the console port on the device, complete the following steps.
Procedure
1. Verify that the device is powered on and that POST is complete by verifying that all power LED
indicators on the power supplies, fans, and blades display a steady green light.
2. Remove the shipping cap from the console (I0I0) port on the active CP blade. The active CP is
indicated by an illuminated blue LED on the CP blade front panel.
Note: The console, or serial port is intended primarily for the initial setting of the IP address and for
service purposes.
3.
Use the serial cable provided with the device to connect the console (serial) port on the active CP to a
computer workstation.
Note: The active CP is indicated by an illuminated blue LED, labeled "Active," on the CP blade front
panel.
If the serial port on the workstation is RJ-45 instead of RS-232, remove the adapter on the end of the
serial cable and insert the exposed RJ-45 connector into the RJ-45 serial port on the workstation.
4. Access the device using a terminal emulator application (such as HyperTerminal in a Windows
environment or tip in a UNIX environment).
5. Disable any serial communication programs running on the workstation (such as synchronization
programs).
6. Open a terminal emulator application (such as HyperTerminal on a PC, or TERM, TIP, or Kermit in a
UNIX environment), and configure the application as follows:
v In a Windows environment:
Parameter Value
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None
Note: Flow control is not supported on the serial consoles when attached to remote terminal
servers and must be disabled on the customer-side remote terminal server and the host-side clients.
v In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
If ttyb is already in use, use ttya -9600 instead.
When the terminal emulator application stops reporting information, press
Enter
. The following
login prompt displays:
CP0 Console Login:
Note: CP0 in the preceding prompt is an example. "CP1" will display if it is the active CP.
7.
Log in to the console using admin as the default login name and password as the default password. As
login to the device occurs, you are prompted to change the device passwords.
Please change passwords for switch default accounts now.
Use Control-C to exit or press ’Enter’ key to proceed.
Initial Setup and Verification
53