IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 59 / 292

Tighten the screws according to specifications under“Torque requirements” on page 21.
1 - Top rail assembly
2 - Air duct assembly
3 - 6-32 x .25 in. (.635 cm) Phillips screw
4 - 10-32 x .5 in. (1.27 cm) Phillips screw with blue Loctite on threads or 10-32 x .63 in.(1.60 cm)
Phillips screw with square cone washer for racks that have rails with round holes
6. Secure the top rail assembly to the rack with four 10-32 screws, two screws on each end of the top rail
assembly.
v For rails with round holes, use two 10-32 screws with washers (refer toFigure 1) on each end of the
top rail assembly. Tighten the screws according to specifications under“Torque requirements” on
page 21.
v For rails with square holes, use the two standard 10-32 screws (refer toFigure 1) with blue Loctite
on the threads and alignment washers (refer toFigure 1) on each end of the top rail assembly.
Tighten the screws according to specifications under“Torque requirements” on page 21.
Figure 14. Securing top rail in rack
Mounting the Device
31