IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 176 / 292

If you have one or more port or extension blades in the device, the Fabric OS automatically detects
mismatches between the active CP firmware and the blade's firmware and triggers the auto-leveling
process. This auto-leveling process automatically updates the application blade firmware to match the
active CP blade. At the end of the auto-leveling process, the active CP and extension blades will run
the same version of the firmware.
4. Enter the
chassisEnable
command to enable all user ports in the chassis and enable a virtual,
fabric-aware chassis.
5. Replace the chassis door. The door is required to meet EMI compliance.
6. Pack the faulty CP blade in the packaging provided with the new CP blade, and contact the switch
supplier to determine the return procedure.
Verifying blade operation
About this task
Perform the following tasks to verify operation of new blade:
Procedure
1. Check the LED indicators on the blade's front panel. For information on interpreting LED patterns,
refer to “Interpreting control processor blade LEDs” on page 88.
2. Enter the following commands and note any error conditions:
v slotShow - Displays the current data on each slot in the system, including blade type, blade ID,
status, model name, and power usage.
v haShow - Displays control processor (CP) status.
v tempShow
- Displays temperature reading of blades.
v sensorShow - Displays temperature reading of blades with fan and power supply status.
v
errDump
- Displays the system error log.
v errShow - Displays error log messages one at a time.
Example
For output examples and additional information on Fabric OS commands, refer to “Using monitoring
commands” on page 97 and the Fabric OS Command Reference.
For more information about error messages, refer to the Fabric OS Message Reference.
148
SAN256B-6 Installation, Service, and User Guide