IBM SAN192C-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 121 / 160

CAUTION:
If the cable does not install easily, ensure that it is correctly oriented before
continuing.
For instructions on verifying connectivity, see the Cisco NX-OS Fundamentals
Configuration Guide.
Maintaining SFP+ and QSFP+ Transceivers and Fiber-Optic
Cables
SFP+ and QSFP+ transceivers and fiber-optic cables must be kept clean and
dust-free to maintain high signal accuracy and prevent damage to the connectors.
Attenuation (loss of light) is increased by contamination and should be below 0.35
dB.
Follow these maintenance guidelines:
v SFP+ and QSFP+ transceivers are static sensitive. To prevent ESD damage, wear
an ESD-preventive wrist strap that is connected to the chassis.
v Do not remove and insert a transceiver more often than is necessary. Repeated
removals and insertions can shorten its useful life.
v Keep all optical connections covered when not in use. If they become dusty,
clean before using to prevent dust from scratching the fiber-optic cable ends.
v Do not touch ends of connectors to prevent fingerprints and other
contamination.
v Clean regularly; the required frequency of cleaning depends upon the
environment. In addition, clean connectors if they are exposed to dust or
accidentally touched. Both wet and dry-cleaning techniques can be effective;
refer to your site's fiber-optic connection cleaning procedure.
v Inspect routinely for dust and damage. If damage is suspected, clean and then
inspect fiber ends under a microscope to determine if damage has occurred.
Figure 39. Connecting the LC-Type Cable to a Fibre Channel Port
Chapter 4. Connecting the IBM c-type SAN Director
97