IBM SAN Volume Controller 2145-8F2, Руководство по установке оборудования

Страница: 55 / 96

Chapter 4. Installing the SAN Volume Controller 2145-8F4 or
the SAN Volume Controller 2145-8F2 hardware
There are several steps that you must perform to prepare and then install the SAN
Volume Controller 2145-8F4 or the SAN Volume Controller 2145-8F2 hardware.
The following topics describe the SAN Volume Controller 2145-8F4 or the SAN
Volume Controller 2145-8F2 hardware installation tasks in the order that they
should be performed.
Note: If you are adding a new I/O group to an existing SAN Volume Controller
cluster, there is no need to turn off the existing, operating cluster nodes.
1. Prepare for the SAN Volume Controller hardware installation by confirming
that you have all the planning information and parts that you require.
2. Optionally, install and verify the redundant ac-power switch, if it is to be used
and is not already being used for a node.
3. Install the uninterruptible power supply.
4. Install the node.
5. Connect the fibre-channel and Ethernet cables to the node.
6. Connect the node to the uninterruptible power supply.
7.
Verify the node.
8. Install and verify the master console, unless it is already installed. Optionally,
this step can be performed first.
After you finish these steps, the hardware installation is complete.
Optionally installing the redundant ac-power switch
Use the redundant ac-power switch to make the SAN Volume Controller cluster
more resilient to power failure.
DANGER
Multiple power cords: The product is equipped with multiple power cords.
To remove all hazardous voltages, disconnect all power cords. (L003)
or
svc00322
1 2
© Copyright IBM Corp. 2003, 2008
31