IBM RS/6000 7025 F50 Series, Руководство по обслуживанию, Страница: 49 / 362

Step 1540-2
1. Turn the power off.
2. If you have not already done so, configure the Service Processor with the
instructions on step 6 on page 2-17 and then return here and continue.
3. Exit Service Processor Menus and remove the power cable.
4. Disconnect all external cables.
5. Remove the side cover
6. Record the slot numbers of the ISA and PCI adapters. Label and record the
location of any cables attached to the adapters. Remove all the adapters.
7. Remove the second processor card (if present). [If second processor removed,
ensure first CPU cable is installed.]
8. Record the position of the memory DIMMs. Remove all installed memory DIMMs
except for one pair from the first Memory card.
Note: The memory DIMM pair must be installed in slots that are next to each
other. For example, install the pair in J1 and J2, not J1 and J3.
9. Remove the second Memory card, if present.
10. Disconnect the SCSI cable from the SCSI connectors on the I/O planar.
11. Disconnect the diskette drive cable from the diskette drive connector on the I/O
planar.
12. Disconnect the internal serial and parallel cables.
13. Plug in the power cable (and wait for OK on the operator panel display).
14. Turn the power on.
15. Wait for the operator panel to stabilize at a checkpoint.
Note: Checkpoints E1F2, E1F3 and STBY are stable as soon as they appear.
Other checkpoints may take up to 3 minutes to assure stability, depending on
system configuration.
D Does the operator panel stabilize with code E1F2, E1F3, E1F7, STBY,
D 20EE000B, or 4BA00830 displayed in the operator panel?
NO Go to “Step 1540-3” on page 2-20.
YES Go to “Step 1540-4” on page 2-21.
Chapter 2. Maintenance Analysis Procedures
2-19