IBM RackSwitch G8000, Руководство по установке

Страница: 53 / 86

Chapter 3. Removing and replacing the RackSwitch and
components
This chapter describes the how to remove and replace the RackSwitch chassis and
the associated options, such as, a 1U air duct module.
For more information to remove and replace individual components, see the
following sections.
v “Removing and replacing the RackSwitch chassis unit from a rack”
v
“Removing the 1U air duct option” on page 41
v “Removing and replacing the main RackSwitch chassis unit” on page 42
Removing and replacing the RackSwitch chassis unit from a rack
This section describes how to remove the RackSwitch chassis unit from supported
equipment racks. For information about removing the RackSwitch from different
racks, see the following sections:
v
“Removing the RackSwitch chassis from a standard equipment rack”
v “Removing the RackSwitch chassis from a System x or Power rack” on page 38
v
“Removing the RackSwitch chassis from an iDataPlex rack” on page 40
Removing the RackSwitch chassis from a standard equipment rack
To remove the RackSwitch from a standard equipment rack, complete the following
steps:
1. Disconnect all cables.
2. Loosen and remove the M6 screws, washers, and clip nuts (or cage nuts) to
remove the switch unit from the rack.
1
2
3
3. Slide the switch out of the rack.
© Copyright IBM Corp. 2013
37