IBM RackSwitch G8000, Инструкция по применению

Страница: 104 / 362

102
RackSwitch G8000: Application Guide
Protocol-Based VLANs
Protocol-based VLANs (PVLANs) allow you to segment network traffic according to
the network protocols in use. Traffic for supported network protocols can be
confined to a particular port-based VLAN. You can give different priority levels to
traffic generated by different network protocols.
With PVLAN, the switch classifies incoming packets by Ethernet protocol of the
packets, not by the configuration of the ingress port. When an untagged or
priority-tagged frame arrives at an ingress port, the protocol information carried in
the frame is used to determine a VLAN to which the frame belongs. If a frame’s
protocol is not recognized as a pre-defined PVLAN type, the ingress port’s PVID is
assigned to the frame. When a tagged frame arrives, the VLAN ID in the frame’s tag
is used.
Each VLAN can contain up to eight different PVLANs. You can configure separate
PVLANs on different VLANs, with each PVLAN segmenting traffic for the same
protocol type. For example, you can configure PVLAN 1 on VLAN 2 to segment IPv4
traffic, and PVLAN 8 on VLAN 100 to segment IPv4 traffic.
To define a PVLAN on a VLAN, configure a PVLAN number (1-8) and specify the
frame type and the Ethernet type of the PVLAN protocol. You must assign at least
one port to the PVLAN before it can function. Define the PVLAN frame type and
Ethernet type as follows:
•
Frame type—consists of one of the following values:
– Ether2 (Ethernet II)
– SNAP (Subnetwork Access Protocol)
– LLC (Logical Link Control)
• Ethernet type—consists of a 4-digit (16 bit) hex value that defines the Ethernet
type. You can use common Ethernet protocol values, or define your own values.
Following are examples of common Ethernet protocol values:
– IPv4 =
0800
– IPv6 =
86dd
– ARP =
0806