IBM QS22 - BladeCenter - 0793, Инструкция по установке и эксплуатации

Страница: 55 / 114

Chapter 5. Configuring the blade server
This chapter describes how to:
v Communicate with a newly-installed blade server.
v
Use System Management Services (SMS) to view and update the system
firmware revision number. This does not require the operating system to be
installed.
v Update the baseboard management controller (BMC) firmware using the update
package and the Advanced Management Module.
v
Update the system firmware using the command-line utility.
v Configure the Ethernet Gigabit dual-port controller in preparation for a network
installation of the operating system.
Note: You can update the BMC firmware through the Advanced Management
Module Web interface without booting the operating system. However, to
update the BMC using the update package or system firmware you must
boot the operating system first. For information about installing the operating
system, see Chapter 6, “Installing the operating system,” on page 55.
Communicating with the blade server
You do not have to boot the operating system before you can communicate with the
QS22 blade server. You can access it through:
Advanced Management Module
The Web-based management and configuration program. This is your main
access method to the blade server.
The command-line interface
See “Using the command-line interface” on page 40 for further information.
Serial over LAN (SOL)
This is similar to the serial interface, but allows you to connect to the blade
server over the network. See “Using Serial over LAN” on page 40 for further
information.
The serial interface
You can connect a PC or compatible terminal directly to the BladeCenter
unit. For BladeCenter H and BladeCenter HT you make this direct
connection using a special cable, for BladeCenter S you use a special
module. See “Using the serial interface” on page 41 for further information.
Note: The BladeCenter unit Serial Breakout cable (or module for
BladeCenter S) is not supplied with the unit and must be ordered
separately.
System Management Services (SMS)
The SMS utility allows you to view and update the VPD, change the boot
device and set network parameters. See “Using the SMS utility program” on
page 41 for further information.
Using the Advanced Management Module
The Advanced Management Module is the main means of administering the
BladeCenter system. Use the Advanced Management Module Web-based
management and configuration program to:
© Copyright IBM Corp. 2006, 2008
39