Disk Drive Assembly Replacement Instructions
This document helps you to complete the following tasks:
v
Remove a failed disk drive and replace it with a new disk drive
v
Verify that the new disk drive is working correctly
Important:
Before you proceed with these instructions, review the IBM Systems Safety Notices provided in
the IBM Media Terms and Conditions CD that is included with your appliance model.
Note:
The illustrations in this document might differ slightly from your appliance model.
Supported appliances
The instructions in this document support IBM
®
QRadar
®
Network Security XGS 5200 (IBM Part Number:
00VM976).
Replacing a storage drive assembly
Before you begin
You must have a replacement storage drive assembly before you remove and replace the failed assembly.
About this task
Identifying the storage drive assembly
The front panel of the appliance contains the storage drive assembly, as highlighted in yellow in the
following figure:
Procedure
1.
Shut down the appliance by using the local management interface (LMI) or the command-line
interface (CLI).
2.
Unplug all of the power cords that are attached to the appliance.
3.
Press the release button on the right side of the storage drive assembly to release the assembly lock.
4.
Pull the drive handle lever to the left to pull the storage drive assembly from the drive bay, as shown
in the following figure:
Figure 1. Location of the storage drive assembly on the front of the appliance
© Copyright IBM Corp. 2017, 2017
1
