IBM Power Systems 8286-42A, Установка

Страница: 36 / 64

a. Open the front door by grasping the door handle and pulling the door at approximately a 120
degree angle to the system.
b.
Pull the door away from the cover.
11. You have now completed the steps to install your server.
Completing the server setup without using an HMC
If you do not have an Hardware Management Console (HMC), use this procedure to complete the server
setup.
To complete the server setup without using a management console, complete the following steps:
1. Attach the server to the rack using the shipping screws (A) that were provided with your system.
A
P8HAJ652-0
If you are installing the system into a rack with round rack-rail holes, use the nut clips that were
included with the system rail kit.
2. To check the firmware level on the managed system and to update the time of day, complete the
following steps:
a. Access the Advanced System Management Interface (ASMI). For instructions, see Accessing the
ASMI without an HMC (http://www.ibm.com/support/knowledgecenter/POWER8/p8hby/
connect_asmi.htm).
b. On the ASMI Welcome pane, note the existing level of server firmware in the upper-right corner
under the copyright statement.
c. Update the time of day. In the navigation area, expand System Configuration.
d. Click Time of Day. The content pane displays a form that shows the current date (month, day,
and year) and time (hours, minutes, and seconds).
e. Change the date value, the time value, or both, and click Save settings.
3. To start a system, complete the following steps:
a.
Open the front door of the managed system.
b. Press the power button on the control panel.
The power-on light begins to flash faster.
20
Power Systems: Installing the IBM Power System S824 (8286-42A)