IBM Power System IC922, Руководство пользователя

Страница: 125 / 146

Procedure
1. Press in the rail safety latches (A) on both rails.
2. Push the system unit back into the rack until both release latches lock into position, as shown in the
following figure.
Figure 75. Placing the system into the operating position
3. If wanted, replace the screws on either side of the system that secure the system to the rack.
Removing and replacing power cords in the 9183-22X system
Find information about removing and replacing power cords in the IBM Power System IC922 (9183-22X)
server.
Disconnecting power cords from the 9183-22X system
To disconnect a power cord, complete the steps in this procedure.
Procedure
1. Open the rear rack door on the system unit that you are servicing.
2. Identify the system unit that you are servicing in the rack.
3. Unfasten the hook-and-loop fasteners that tie the power cords to the power supply handle.
Note how the power is looped, you need to make that same loop when you reattach the power cords.
Installing and configuring the 9183-22X 111