IBM Power System 5148-22L, Руководство пользователя

Страница: 74 / 204

8.
On the console, press
Enter
to indicate that you installed the drive.
9. If you are replacing more than one drive, repeat the steps in this procedure until all drives are
replaced.
10. Proceed to the procedure for preparing the system for operation. For instructions, see “Preparing the
8284-21A or 8284-22A system for operation after replacing a drive with the power turned on in AIX”
on page 57.
11. If you are replacing a solid-state drive in an expanded function system, continue with the next step.
12. With the SSD drive bay handle (A) in the unlocked position, pull the lever outward to gain access to
the guide rails in the SSD slot. Support the bottom of the SSD as you align it with the guide rails in
the SSD slot. See Figure 56 on page 57.
Note: Support the drive by holding the drive by its sides.
13.
Slide the drive halfway into the system.
14. On the console, select the drive that you want to install and then press Enter .
15. When the identify LED turns on solid, slide the drive all the way into the system until the drive
stops.
16. Lock the drive by rotating the bay handle (A) in the direction that is shown in Figure 56 on page 57.
Important: When you install an SSD, ensure that the SSD is fully seated and is all the way into the
system.
P8HAL505-1
A
Figure 55. Replacing a disk drive in an expanded function system
56
Disk drives or solid-state drives