IBM Power System 5148-22L, Руководство пользователя

Страница: 38 / 204

20.
On the console, press
Enter
to indicate that you installed the drive.
21. If you are installing more than one drive, repeat the steps in this procedure until all drives are
installed.
Preparing the 8284-21A or 8284-22A system for operation after installing a disk
drive or solid-state drive with the power turned on in AIX
Learn to prepare the system for operation after you install a disk drive or solid-state drive (SSD) in the
system with the AIX operating system or AIX logical partition that controls the drive location powered
on.
To prepare the system for operation, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is
connected to an unpainted metal surface. If not, do so now.
2. On the front of the system, verify that the power LED is ON (green) for the installed or replaced
drive.
3. If applicable, cover the SSD cage with the perforated plate (A) as shown in Figure 17 on page 21.
P8HAL507-2
A
Figure 16. Installing an SSD in an expanded function system
20
Disk drives or solid-state drives