IBM Power 720 Express 8202-E4B, Руководство пользователя

Страница: 82 / 228

Proceed to the procedure for completing the replacement by using the diagnostic command. For
instructions, see “Completing the disk drive or solid-state drive replacement by using the diagnostic
command” on page 67.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2.
Slide the solid-state drive halfway into the EDR1 PCIe storage enclosure.
3. Select the drive that you want to replace and press Enter on the console.
4.
When the solid-state drive identify LED turns on solid, slide the solid-state drive all the way into the
EDR1 PCIe storage enclosure until it is fully seated. Then rotate the handle
(A) to the locked position.
See Figure 44 on page 67.
5. On the console, press Enter to indicate that you have installed the solid-state drive.
6. Install the bezel (B) .
Figure 43. Replacing a solid-state drive in the 5888 PCIe storage enclosure.
66
Disk drives or solid-state drives