IBM NetVista 6029, Руководство по техническому обслуживанию аппаратной части

Страница: 31 / 136

The following illustration shows the locations of parts on the system board.
1
Fan connector
9
Secondary IDE connector
2
Microprocessor
10
Primary IDE connector
3
DIMM connector 1
11
Front USB connector
4
DIMM connector 2
12
Battery
5
Power connector
13
Virtual clear CMOS/BIOS recovery
jumper (JP14)
6
Hard disk LED connector
14
PCI slots
7
Power LED connector
15
CD-ROM audio connector
8
Diskette drive connector
16
Front panel connector
Installing memory
The computer has three connectors for installing dual in-line memory modules
(DIMMs) that provide up to a maximum of 512 MB of system memory.
Installing and removing DIMMs
When installing DIMMs, the following rules apply:
v
Fill each system memory connector sequentially, starting at DIMM 1
v
Use 3.3 V, synchronous, 168-pin, unbuffered, 133 MHz nonparity synchronous
dynamic random access memory (SDRAM)
v
Use 64 MB, 128 MB, or 256 MB DIMMs in any combination
v
DIMM heights of 38.1 mm (1.5 inches)
To install a DIMM:
1. Remove the cover. See “Removing the cover” on page 23.
2.
You might have to remove an adapter to gain access to the DIMM slots. See
“Installing and removing adapters” on page 27.
Chapter 5. Installing Options
25