IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 96 / 212

b. When the ServeRAID Mini-Configuration prompt appears,
press Ctrl+i. When a system contains more than one
ServeRAID adapter or controller, a selection screen appears.
c. The menu lists the ServeRAID adapters and controllers in
order. Select the first ServeRAID adapter or controller from
the menu.
d. Select Advanced Functions from the Main Menu.
e. Select View Controller and PCI Information from the
Advanced Functions menu.
f. Record the slot number for the ServeRAID adapter or
controller; then, press Esc three times to return to the
controller selection screen.
g. Repeat step 3c through step 3f until you record the slot
number for each ServeRAID adapter or controller that
appears on the selection screen.
4. Turn off the system; then, remove all ServeRAID, IDE, and SCSI
disk-storage adapters and controllers except the one attached to
the drive where you intend to install UnixWare.
Note: If one of the disk-storage or ServeRAID controllers that
you need to remove is on the system board, do one of
the following:
Ÿ
If the CD-ROM drive that you are using to install your
operating system is attached to the integrated
controller, disconnect or remove all disk drives
attached to the integrated controller.
Ÿ
If only disk drives are attached to the integrated
controller, disconnect the SCSI or IDE cable for the
integrated controller from the connector on the
system board. See the label inside the server cover
for the location of the SCSI and IDE cable
connectors.
5. Follow the instructions in “Installing the Files while Installing
UnixWare” on page 87; then, return here and continue with
step 6.
6. Power down the system.
86
IBM ServeRAID-3H and ServeRAID-3L Adapters