IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 91 / 212

The system will respond with a successful message.
9. Use shutdown to bring down the system; then, restart the
system.
Using an IDE CD-ROM Drive to Install OpenServer Files
This section contains instructions for installing files for OpenServer
5.0.0, OpenServer 5.0.2, and OpenServer 5.0.4 when using an IDE
CD-ROM Drive.
Installing the Files for OpenServer 5.0.0
To install files for OpenServer 5.0.0 using an IDE CD-ROM drive:
1. Type the following at the
BOOT
prompt:
restart ahslink="ATAPI ipsraid" Srom=wd(ð,ð,ð,ð)
2. Insert the ATAPI BTLD diskette when prompted; then, press r to
replace the wd driver.
The fields for the ATAPI CDROM are:
Srom=wd( c,d,l,b) where:
c = primary (0) or secondary (1) IDE/EIDE controller
d = master (0) or slave (1) device
l = LUN of device (always 0 with ATAPI or wd driver)
b = BUS of device (always 0 with ATAPI or wd driver)
Installing the Files for OpenServer 5.0.2 and 5.0.4
To install files for OpenServer Versions 5.0.2 or 5.0.4 using an IDE
CD-ROM drive:
1. Type the following at the
BOOT
prompt:
restart link=ipsraid Srom=wd(ð,ð,ð,ð)
Note: The ATAPI BTLD (which includes the wd driver) is
included in OpenServer 5.0.2 and 5.0.4.
The fields for the ATAPI CDROM are:
Srom=wd( c,d,l,b) where:
Chapter 4. Installing Device Drivers and Utility Programs
81