IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 89 / 212

which they are attached. External Channel 1 connector is Bus
Number 1, external Channel 2 connector is Bus Number 2, and
internal Channel 3 connector is Bus Number 3.
To configure the default nondisk devices during the initial installation:
1. Redefine the default tape drive in the initial bootstring. For
example, to install the IPSRAID BTLD and redefine the tape
drive, go to the
BOOT
prompt and type:
link Stp=ips(ð, 1, 2, ð)
The numbers in parentheses represent the Host Adapter
Number, the Bus Number, the SCSI ID, and the LUN
respectively.
2. When prompted for the location of the installation CD, change
the Bus Number and SCSI ID, as required.
Adding BTLD at Boot Time: To install the ServeRAID device
driver for OpenServer, Version 5.0.X:
1. At the
BOOT
prompt, type:
link
2. Press Enter; then, when asked for the name of the package to
load, type:
ipsraid
3. Press Enter.
4. After the kernel loads but before it runs,
link
prompts you to
insert the IBM ServeRAID Device Drivers for SCO Operating
Systems Diskette.
While the installation program copies the files, one or both of the
following messages might appear:
Messages:
a.
Extracting BTLD distribution for ipsraid... /etc/uadmin
getdev b ips: No such device (error 19)
b.
dynamic linker: dlvr_audit: Cannot open /dev/zero for
file /lib/libprot.so.1
You can ignore Message A, no action is required. But if
Chapter 4. Installing Device Drivers and Utility Programs
79