IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 84 / 212

Installing Device Drivers for OS/2
This section provides two sets of instructions for installing the
ServeRAID device driver: one that you can use during the initial
OS/2 installation and one that you can use if OS/2 already is
installed.
The ServeRAID Administration and Monitoring Program files and
background-server component for OS/2 install automatically when
you install the ServeRAID device driver for OS/2.
Installing the Files while Installing OS/2
You can use the following instructions to install the ServeRAID
device driver and Administration and Monitoring Program files while
installing OS/2 Warp Server.
Note: If you install these files on a logical drive that has its write
policy set to the write-back mode, wait at least 10 seconds
after being prompted to press Ctrl
+
Alt
+
Del before you
actually press the keys. Waiting 10 seconds or longer gives
the ServeRAID adapter or controller the time needed to flush
all dirty-cache pages out to the hard disk.
To install the ServeRAID files while installing OS/2:
1. Make a copy of the
OS/2 Warp Diskette 1 and label it Copy of
OS/2 Diskette 1.
2. Copy the IPSRAID.ADD file from the OS2 directory on the
IBM
ServeRAID Device Driver Diskette to the Copy of OS/2
Diskette 1.
If there is not enough space, delete files not needed in your
installation (such as proprietary CD-ROM or SCSI device
drivers). Make sure you remove all entries referring to any
device drivers you delete from the CONFIG.SYS file.
3. Edit the CONFIG.SYS file on the Copy of OS/2 Diskette 1 to add
the following lines:
BASEDEV=IPSRAID.ADD
SET COPYFROMFLOPPY=1
74
IBM ServeRAID-3H and ServeRAID-3L Adapters