IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 74 / 212

running the OS/2, NetWare, Windows NT, UnixWare, or
OpenServer operating system. Use the instructions in this
section to install the WIN32-Based program on the Windows 95
client.
Ÿ
If your network operating system is OS/2, NetWare, OpenServer,
or UnixWare, you must run the ServeRAID WIN32-Based
program remotely, in the client/server mode.
Other requirements for this environment include:
– A Windows NT or Windows 95 client running the IBM
ServeRAID WIN32-Based program
Use the instructions in this section to install the
WIN32-Based program.
– A network adapter with proper cabling for access to the
remote systems
– The TCP/IP networking protocol installed on both the local
and remote systems
– The ServeRAID device driver and background-server
component installed on the remote system
Refer to “Installing ServeRAID Device Drivers” on page 65
for more information.
To install the ServeRAID WIN32-Based program:
1. Turn on the system and allow Windows NT or Windows 95 to
start.
2. Insert the IBM ServeRAID Configuration CD into the CD-ROM
drive.
3. Click on Start, click on Run; then, type the following:
z:\programs\disk3\setup
Note: The
z represents the letter assignment for the CD-ROM
drive that contains the ServeRAID CD.
4. Press Enter; then, follow the instructions that appear on the
screen to complete the installation.
64
IBM ServeRAID-3H and ServeRAID-3L Adapters