IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 64 / 212

When you select the Advanced Functions choice from the Main
Menu, the following choices appear on the screen.
Attention:
Be careful when making selections from this menu. If you change
the configuration, you might lose data.
Ÿ
Initialize Configuration lets you reset the configuration. You
will not have access to any data stored on the logical drives
attached to the selected ServeRAID adapter or controller.
This choice deletes the existing configuration information, sets all
functional hard disk drives attached to the controller to the Ready
state, and deletes all logical drives defined for the controller.
This choice does not change any of the ServeRAID adapter or
controller settings (such as the stripe-unit size, rebuild rate, and
so on) from their current or customized values.
Ÿ
Import Configuration from Drive reads the most common
configuration from the drives in the system and copies it to the
ServeRAID adapter or controller NVRAM and EEPROM module.
Ÿ
Configure BIOS Settings lets you modify the BIOS settings,
such as the Bootable CD-ROM and INT13 Extensions settings,
for the ServeRAID adapter or controller. (See “Setting the
Bootable CD-ROM Feature” on page 55 for more information.)
Notes:
1. The Multiple Controller mode has two settings: Erase and
Shrink. When this parameter is set to Erase, redundant
copies of the ServeRAID BIOS are erased. When this
parameter is set to Shrink, the extra copies of the
ServeRAID BIOS are removed from memory, but stored for
future use. When you have multiple ServeRAID adapters
and controllers installed, you need only one active copy of
ServeRAID BIOS. However, to ensure that you will have a
copy of the ServeRAID BIOS available if your active copy
becomes defective or unavailable, leave the Multiple
Controller parameter set to Shrink.
2. Only one adapter or controller in the system can support the
INT13 extensions.
54
IBM ServeRAID-3H and ServeRAID-3L Adapters