IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 159 / 212

replace the ServeRAID adapter or controller in an existing
ServeRAID subsystem.
You also might press F7 if you replace a whole set of drives with
drives that were configured in another server with a ServeRAID
adapter or controller.
Note: When you install drives in a server that has no logical
drives defined, the F7 choice will not appear. The ServeRAID
adapter or controller does not contain any logical drives in its
factory configuration. Therefore, F7 will not appear. In this case,
do the following:
1. Restart the server and press Ctrl
+
I to enter the
Mini-Configuration program (see “Using the ServeRAID
Mini-Configuration Program” on page 51).
2. Select Advanced Functions.
3. Select Import Configuration from Drives to Adapter and
follow the instructions on the screen.
NVRAM Cache Controller Not Responding
Explanation: BIOS code detected a bad or failed NVRAM.
Action: Press F9 to remove the NVRAM cache controller from the
configuration, or press F10 to exit without change.
NVRAM Cache Controller Replacement
Explanation: The ServeRAID controller detects that the NVRAM cache
controller is defective.
Action: Press F8 if you replaced the NVRAM cache controller, or press
F10 if you have not replaced the NVRAM cache controller.
Recoverable configuration error
Explanation: The configuration data stored in NVRAM does not match the
configuration data stored in the EEPROM.
Action:
1. Press Ctrl
+
Alt
+
Del to restart the system.
2. Start the ServeRAID Mini-Configuration Program. (See “Using the
ServeRAID Mini-Configuration Program” on page 51 for instructions.)
Chapter 6. Solving ServeRAID Problems
149