IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 156 / 212

Controller is not responding to commands. No logical drives are
installed.
Explanation: The ServeRAID adapter or controller is not operational.
Action: Have the system serviced.
Error: Cannot disable this adapter BIOS.
Explanation: The ServeRAID adapter or controller was unable to prevent
an extra copy of its BIOS code from being stored on the server. This
condition occurs when the server contains multiple ServeRAID adapters or
controllers.
Action: This is an information message. No action is required.
Following drives not responding
(old state: new state ch: SID)
Explanation: One or more drives did not respond to the ServeRAID
adapter or controller. For example, the ServeRAID adapter or controller
detected a new drive at an unconfigured SCSI ID, and the drive is not part of
the current configuration. This might also occur if the ServeRAID adapter or
controller detected that a configured drive is missing.
Action: Select F5 to accept the new state that the ServeRAID adapter or
controller will assign to the drive. For example, the ServeRAID adapter or
controller will assign the drive a state of defunct (DDD) or empty (EMP).
A hard disk drive in the defunct state does not necessarily mean that you
need to replace the drive. Before you replace the drive, ensure that:
1. All cables are connected properly to the backplane or system board, and
to the hard disk drive. Also, ensure that all cables inside the server are
connected properly.
2. The hot-swap drive trays are seated properly in the drive bay.
3. If you have not already attempted to rebuild the drive, try rebuilding it.
See “Rebuilding a Defunct Drive” on page 159 for more information.
After you perform these steps, if the hard disk drive does not function
properly, replace the drive.
For more information, see “Configured drives are missing.” on page 143.
146
IBM ServeRAID-3H and ServeRAID-3L Adapters