IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 14 / 212

Attention:
The default setting for the stripe-unit size is 8 KB
1 . If you want
to use a different setting, be sure to change the stripe-unit size
before you store data in the logical drives. After you store data
in the drives, you cannot change the stripe-unit size without
destroying data in the logical drives. (See “Interleave Depth
and Stripe-Unit Size” on page 5 and page 46 for more
information.)
Ÿ
If you are configuring a ServeRAID-3H Ultra2 SCSI Adapter
or a ServeRAID-3L Ultra2 SCSI Adapter, see Chapter 3,
“Using the Configuration Programs” on page 19 for
instructions.
Ÿ
If you are configuring an IBM ServeRAID controller that
came as a standard feature on an IBM Netfinity or PC
Server system board, see the installation instructions and
CDs provided with your server for information about starting
the configuration programs for the server.
4
Install your operating system, ServeRAID device drivers, and
ServeRAID utility programs.
You can skip this step if you are installing multiple ServeRAID
adapters and you already installed your operating system and
the most current versions of the ServeRAID device drivers and
utility programs.
Ÿ
To install these files for a ServeRAID-3H Ultra2 SCSI
Adapter or a ServeRAID-3L Ultra2 SCSI Adapter, see the
information provided with your operating system and
Chapter 4, “Installing Device Drivers and Utility Programs”
on page 57 for instructions.
Ÿ
To install these files for an IBM ServeRAID controller that
came as a standard feature on an IBM Netfinity or PC
Server system board, see the installation instructions and
CDs provided with your server for instructions.
1 KB equals approximately 1000 bytes.
4
IBM ServeRAID-3H and ServeRAID-3L Adapters