IBM Netfinity ServeRAID-3H, Инструкция по установке и эксплуатации, Страница: 128 / 212

Notes:
1. The ServeRAID adapter or controller can perform only one
Rebuild operation at a time.
2. If the array contains a critical (CRT) logical drive, the Rebuild
operation changes the hard disk drive state from DDD to RBL.
After the Rebuild operation completes, the hard disk drive state
changes from RBL to ONL. (If you rebuild to a RDY drive, the
DDD drive is removed from the disk array and becomes a
defunct hot-spare (DHS).)
3. The hard disk drive being rebuilt must be the same size or larger
than the failed drive.
4. If a hot-spare (HSP) drive is available, a Rebuild operation will
start automatically.
5. If multiple hot-spare (HSP) drives are available, the ServeRAID
adapter or controller searches all the drives on each channel for
a hot-spare drive of the appropriate size. The first appropriate
hot-spare drive found enters the Rebuild (RBL) state.
Adapter Administration
This section provides instructions for copying the drive configuration
to the ServeRAID adapter or controller, copying the ServeRAID
adapter or controller configuration to the drives, initializing the
adapter or controller configuration, and scanning for new drives.
Copying the Drive Configuration to the Adapter:
This operation is useful when drives are imported from other
systems.
You can copy the configuration stored on the hard disk drives
to the ServeRAID adapter or controller.
118
IBM ServeRAID-3H and ServeRAID-3L Adapters