IBM N7700, Руководство по аппаратуре и обслуживанию, Страница: 89 / 182

Administration Guide for more information about secure shell client applications.
Procedure
1.
Log into the RLM console from a remote host acting as a system console by
entering the following command from the administration host prompt:
ssh
user_name @ RLM_IP_address
Note: Root login is not allowed for the RLM. If you need to log in with root
credentials, use naroot for root login.
admin-host> ssh admin@10.10.123.45
admin@172.22.136.85’s password:*********
RLM admin-host>
2. Check the RLM status by entering the following command from the RLM
console:
rlm status
3. Exit the RLM console by entering the following command:
exit
4. Connect to the system console using the serial connection or through telnet.
5. Test the RLM AutoSupport functions by sending a test e-mail to AutoSupport
with the following command from the system console:
rlm test autosupport
Running diagnostics on the RLM
You should run diagnostics on the RLM to confirm its operation.
Procedure
1.
Reboot the system and interrupt the boot process.
2. Enter the following at the prompt:
boot_diags
3. Select the RLM tests from the main menu, and then run all diagnostics.
4. Correct any errors.
5. Exit diagnostics by entering the following command:
exit
6. Return the system to normal operation:
If your system is... Then issue this command...
In an HA pair
1. Run the
cf giveback
command (if in a
7-Mode system) or the storage failover
giveback
command (if in a Cluster-Mode
system) from the partner node console.
2. On the console of the target controller
module, select option 1 from the
displayed menu to boot Data ONTAP:
Normal Boot (option 1)
Stand-alone Enter the following command at the prompt
to boot the system:
boot_ontap
Completing the replacement process
Return the failed part to IBM. Contact IBM Service and Support at 1-800-IBM-SERV
(1-800-426-7378) for more information on the return procedure.
Chapter 5. Replacing N7000 series system devices
63