IBM N Series, Руководство по внедрению

Страница: 66 / 105

52 Process overview for physically moving the disk shelf
Process overview for physically moving the disk shelf
The following table provides an overview of the process for physically moving
the shelf and tells you where to find the procedure for how to do each step.
Step Action Where to find instructions
1 On the N series storage system,
disconnect the disk shelf.
Note
You must shut down the N series
storage system to remove the
disk shelf from it.
See the appropriate guide for your disk shelf.
2 Connect the disk shelf to the
gateway controller, ground the
Fibre Channel disk shelves and
the controller, and connect the
disk shelves to the power source.
Note
You do not need to shut down the
gateway to install a disk shelf on
it.
◆
For a stand-alone system, see the hardware Installation
and Setup Overview for your platform and the disk shelf
guide for your disk shelf.
◆
For an HA pair, see the Data ONTAP High Availability
Configuration Guide or Data ONTAP Active/Active
Configuration Guide .
3 Set up the disk shelf See the appropriate guide for your disk shelf.