22
BootUp Num-
Lock
This item determines if the Num Lock key is
active or inactive at system start-up time.
Floppy Drive
Swap
If you have two diskette drives installed and
you enable this item, drive A becomes drive B
and drive B becomes drive A.
Floppy Drive
Seek
If you enable this item, your system will check
all floppy disk drives at start up. Disable this
item unless you are using an old 360KB drive.
Password Check
If you have entered a password for the system,
use this item to determine, if the password is
required to enter the Setup Utility (
Setup
) or
required both at start-up and to enter the Setup
Utility (
Always
).
Boot to OS/2 >
64MB
Enable this item if you are booting the OS/2
operating system and you have more than
64MB of system memory installed.
L2 Cache
Leave these items enabled since all the
processors that can be installed on this board
have internal cache memory.
System BIOS
Cacheable
If you enable this item, a segment of the
system BIOS will be cached to main memory
for faster execution.
DRAM Timing by
SPD
This item enables or disables the SDRAM
timing defined by the Serial Presence Detect
electrical.
DRAM CAS#
Latency
This item determines the operation of SDRAM
memory CAS (column address strobe). It is
recommended that you leave this item at the
default value. The 2T setting requires faster
memory that specifically supports this mode.
DRAM Bank
Interleave
Enable this item to increase SDRAM memory
speed. When enabled, separate memory banks
are set for odd and even addresses, and
upcoming byte of memory is accessible while
refreshing the current byte.
