IBM LTO Ultrium 4, Инструкция по установке и эксплуатации

Страница: 35 / 92

Procedure
1.
Press the unload button three times within two seconds to clear the error code
and return to Function Code
0
.
2. Press and hold the unload button for three or more seconds, then release it.
Results
Note: The drive will exit Maintenance Mode automatically when:
v
it completes a maintenance function
v
there is an error code for anything other than a hardware problem
v
no action has occurred for 10 minutes
The drive will not exit Maintenance Mode automatically if there is an error
code displayed that indicates there is a hardware problem.
Function Code 0: Maintenance Mode
About this task
Function Code
0
makes the drive available for running drive diagnostics or
maintenance functions, or exiting from Maintenance Mode.
Procedure
1. Place the drive in Maintenance Mode. For instructions, see“Entering
Maintenance Mode” on page 18.
2.
To exit Maintenance Mode, see “Exiting Maintenance Mode” on page 18.
Results
The drive exits Maintenance Mode automatically after it completes a maintenance
function or after 10 minutes if no action has occurred.
Function Code 1: Run drive diagnostics
About this task
Approximate Run Time = 20 minutes per loop
Total Number of Loops = 10
Function Code
1
runs tests that determine whether the drive can properly load
and unload cartridges and read and write data.
Press the unload button to stop the diagnostic and exit Maintenance Mode.
Pressing the unload button once will abort the test at the end of the current test
loop. Pressing the unload button twice will abort the test immediately. Wait for the
drive to rewind the tape and unload the cartridge.
Record the time it takes for the test to complete. Compare the recorded time with
the approximate run time. If the test runs successfully but the execution time is
significantly longer than the approximate run time, run “Function Code F: Write
performance test” on page 30. If the Write Performance Test fails, replace the
media.
Chapter 3. Operating
19