IBM LS42 - BladeCenter - 7902, Инструкция по установке и эксплуатации

Страница: 36 / 90

9. Put the hard disk drive or solid-state drive into the drive tray and push it into the
SAS connector, until the drive moves past the SAS drive release lever.
If you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 46.
Removing a SAS drive
The following illustration shows how to remove a SAS drive from the blade server.
1. Read the safety information beginning on page “Safety” on page v and
“Installation guidelines” on page 17.
2. Open the blade server cover (see “Opening the blade server cover” on page 20
for instructions).
3. If you are removing a SAS drive from the blade server and an MPE unit or an
expansion unit is connected to the blade server, remove the device (see
“Removing an expansion unit” on page 21).
4. Press the release lever away from the SAS drive; then, remove the SAS drive.
Note: Press the release lever away from the SAS drive; then, remove the SAS
drive.
Attention: If two SAS drives are installed, you might damage one or both of
the drives if you use too much force to remove the drive.
v
If you are removing a SAS drive from SAS connector 0, slide the drive
backward to disengage it from the connector at the front of the drive tray;
then, lift the drive out of the drive tray.
v If you are removing a SAS drive from SAS connector 1, slide the drive
forward to disengage it from the connector at the rear of the drive tray then,
lift the drive out of the drive tray.
26
BladeCenter LS22 and LS42 Type 7901 and 7902: Installation and User’s Guide