IBM L5X, Инструкция по установке и эксплуатации

Страница: 55 / 120

example, Gen 3 media), error code
P
appears in the SCD. In either case,
the tape drive unloads the cartridge and exits Maintenance mode after the
cartridge is removed.
To execute Function code J: Fast read/write test, complete the following steps:
1. Put the drive in Maintenance mode. For instructions, see “Entering
Maintenance mode” on page 25.
2. Press the Unload button once per second until
J
appears in the SCD. (If you
cycle past the desired code, press the Unload button once per second until the
code reappears.)
3.
Press and hold the Unload button for 3 or more seconds, then release it to
select the function. The SCD changes to a flashing
C
.
4.
Insert a scratch (blank) data cartridge. The SCD changes to a flashing
J
and
the tape drive runs the tests.
v
If no error is detected, the diagnostic will loop and begin again. To stop the
loop, press the Unload button for 1 second and release. When the loop ends,
0
temporarily appears in the SCD.
v
If an error is detected, the status light flashes amber and the drive posts an
error code to the SCD. To determine the error, locate the code in Appendix C,
“Error codes and messages,” on page 59. To clear the error, either turn the
power off and then on again, or restart the drive by pressing and holding the
Unload button for 10 seconds.
Function code L: Load/unload test
Approximate Run Time = 15 seconds per loop
Total Number of Loops = 10
Function code
L
tests the ability of the drive to load and unload a tape cartridge.
Press the Unload button to stop the diagnostic and exit Maintenance mode. Press
the Unload button once to abort the test at the end of the current test loop. Press
the Unload button twice to abort the test immediately. Wait for the drive to rewind
the tape and unload the cartridge.
Attention: Even though no data is written during this test, use a blank (scratch)
cartridge for this test.
To execute Function code L: Load/unload test, complete the following steps:
1. Put the drive in Maintenance mode. For instructions, see “Entering
Maintenance mode” on page 25.
2. Press the Unload button once per second until
L
appears in the SCD. (If you
cycle past the desired code, press the Unload button once per second until the
code reappears.)
3.
Press and hold the Unload button for 3 or more seconds, then release it to
select the function. The SCD changes to a flashing
C
.
Chapter 3. Operating
37