Figure 4: Load the Device onto the Lift
OK
MASTER
FAN
ONLINE
OFFLINE
0
1
1
0
FAIL
FAIL
PEM
FAIL
FAIL
FAIL
FAIL
FAIL
FAIL
ESD
OK
OK
OK
OK
OK
OK
OK
2
3
4
5
ACO/LT
YELLOW ALARM
RED ALARM
NC
NO
C
NC
NO
C
REO
RE1
0 1 2 3
SCB
SCB
g004247
3.
Using the lift, position the device in front of the rack or cabinet, centering it in
front of the mounting shelf.
4.
Lift the chassis approximately 0.75 in. above the surface of the mounting shelf
and position it as close as possible to the shelf.
5.
Carefully slide the device onto the mounting shelf so that the bottom of the
chassis and the mounting shelf overlap by approximately two inches.
6.
Slide the chassis onto the mounting shelf until the mounting brackets contact
the rack rails. The shelf ensures that the holes in the mounting brackets and the
front-mounting flanges of the chassis align with the holes in the rack rails.
7.
Move the lift away from the rack.
8.
Install a mounting screw into each of the open mounting holes aligned with the
rack, starting from the bottom.
9.
Visually inspect the alignment of the device. If the device is installed properly in
the rack, all the mounting screws on one side of the rack should be aligned with
the mounting screws on the opposite side and the device should be level.
Step 3: Install the Device
■
9
Step 3: Install the Device
