IBM IntelliStation Z Pro 6221, Руководство по техническому обслуживанию аппаратной части, Страница: 112 / 168

Error code/symptom FRU/action
01298101 (Bad update data
for microprocessor 1)
1. Ensure all microprocessors are the same cache size.
2. Microprocessor 1.
01298102 (Bad update data
for microprocessor 2)
1. Ensure all microprocessors are the same cache size.
2. Microprocessor 2.
01298200 (Microprocessor
speed mismatch)
v Ensure all microprocessors are the same speed.
I9990301 (Fixed boot sector
error)
1. Hard disk drive
2. If RAID system, RAID adapter
3. SCSI backplane
4. Cable
5. System board
I9990305 (Fixed boot sector
error, no operating system
installed)
v
Install operating system to hard disk drive.
I9990650 (AC power has
been restored)
1. Check cable.
2. Check for interruption of power supply.
3. Power cable.
Other numbers
v
Follow instructions on screen.
System board LEDs
If the system error LED on the front panel is not lit and no LEDs on the system
board are lit, the LEDs have not detected a system error.
If the system error LED on the front panel is lit and one or more system board
LEDs are lit, take the action described in the following table:
System board LED FRU/action
Fan
v Replace the fan assembly indicated by lit fan LED.
Memory
v
Replace the DIMM indicated by the lit DIMM LED.
Microprocessor
1. Turn off the server, reseat the microprocessor, and restart the server.
2. Replace the microprocessor.
POST (ISPR) error procedures
Use the ISPR error procedures to help you solve ServeRAID problems. A complete
list of error codes is listed at “ServeRAID error codes” on page 104.
Note: Where the ISPR Error Procedures refer to a hard disk drive backplane, see
the chapter of this publication that concerns field replaceable units.
EF10 (Default ISPR)
1. No ISPR error present.
9 ZXX through B ZXX (SCSI bus error caused by cables, termination, or defective
drives.)
102
IBM IntelliStation Z Pro Type 6221: Hardware Maintenance Manual