IBM IntelliStation M Pro, Руководство по техническому обслуживанию аппаратной части

Страница: 49 / 190

5. Rotate the drive bay cage until the latch catches the front of the computer
chassis.
6. Touch the static-protective package containing the drive to any unpainted metal
surface on the computer; then, remove the drive from the package and place it
on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
8. Slide the drive into the drive bay, and then attach the drive to the drive cage
with the screws.
9. Connect one end of the parallel IDE or serial ATA IDE signal cable into the
back of the drive and the other end of the cable into the parallel IDE or serial
ATA IDE connector on the system board. For the location of the parallel IDE or
serial ATA IDE connectors, see “System-board internal connectors” on page
33.
Note: Make sure to route the signal cable so that it does not block the airflow
to the rear of the drives or over the microprocessor.
10. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
11. If you have other options to install or remove, do so now.
12. Replace the cover and frame-support bracket. See “Replacing the cover” on
page 47 and “Removing and installing the support bracket” on page 35 for
details.
13. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Installing a drive in bay 2
Complete the following steps to install or replace a drive in bay 2:
1. Follow the instructions in “Preinstallation steps” on page 38.
2. Turn off the computer and attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the cover and frame-support bracket. See “Removing the cover” on
page 34 and “Removing and installing the support bracket” on page 35 for
details.
5. Disconnect power and signal cables to the drive.
Installing options
39