IBM iDataPlex dx320 6385, Руководство пользователя

Страница: 34 / 60

Installing a 3.5-inch simple-swap hard disk drive
To install a 3.5-inch simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 17.
2. Turn off the system-board tray and all attached devices (see “Turning off the
system-board tray” on page 15).
3. Remove the filler panel from the simple-swap hard disk drive bay.
4. Touch the static-protective package that contains the hard disk drive to any
unpainted metal surface on the outside of the system-board tray for at least 2
seconds; then, remove the hard disk drive from the package.
Attention: Do not press on the top of the drive. Pressing the top might
damage the drive.
5. Align the drive with the guide rails in the drive bay.
6. Pull the loops of the drive toward each other; then, carefully slide the drive into
the bay until it stops, and release the loops.
Note: Do not release the loops on the drive until it is completely seated.
7. Install the filler panel in the simple-swap hard disk drive bay.
If you have other devices to install, do so now. Otherwise, turn on the system-board
tray (see “Turning on the system-board tray” on page 14).
22
IBM iDataPlex dx320 User's Guide