IBM iDataPlex dx320 6385, Руководство пользователя

Страница: 33 / 60

Removing a 3.5-inch simple-swap hard disk drive
To remove a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 17.
2. Turn off the system-board tray and all attached devices (see “Turning off the
system-board tray” on page 15).
3. Remove the filler panel from the simple-swap hard disk drive bay.
4. Pull the loops of the drive toward each other; then, pull the drive out of the drive
bay.
Note: A hard disk drive or filler panel must always be installed in each drive
bay when the server is turned on. Simple-swap disk drives must always have a
filler panel installed along with the hard disk drive.
5. Store the drive and filler panel for later use.
Chapter 3. Installing optional devices
21