IBM i Series, Руководство пользователя

Страница: 340 / 908

I/O Adapters and Controllers
310
iSeries Handbook
This feature supports the SLIP, PPP, SDLC, and Fax protocols. An asynchronous line
description is required that can only be used for fax. The #2761 is configured as a single IOA
with eight individual resources available.
This feature requires country certification or homologation.
#2815 PCI 155 Mbps Unshielded Twisted Pair ATM IOA
This feature allows the iSeries server to be attached to an Asynchronous Transfer Mode
(ATM) network using the Unshielded Twisted Pair (UTP-5) interface. This interface is intended
for connection to both local area switches and direct connection to service provider
equipment. The #2815 is typically used where 155 Mbps speeds are required over distances
of less than 100 meters.
#2816 PCI 155 Mbps Multi-Mode Fiber OC3 ATM IOA
This feature allows the iSeries server to be attached to an Asynchronous Transfer Mode
(ATM) network using the Multi-Mode Fiber (MMF) 62.5 micron interface. This interface is
intended for connection to both local area switches and direct connection to service provider
equipment. The #2816 is typically used where 155 Mbps speeds are required over distances
of less than 2 km.
#2818 PCI 155 Mbps Single-Mode Fiber OC3 ATM IOA
This feature allows the iSeries server to be attached to an Asynchronous Transfer Mode
(ATM) network using the Single-Mode Fiber (SMF) 9 micron interface. This interface is
intended primarily for direct connection to service provider equipment but can be used for
local area switches. The #2818 is typically used where 155 Mbps speeds are required over
distances from 16 to 40 km.
#2838/#9738 PCI 100/10 Mbps Ethernet IOA
This feature allows the iSeries server to attach to a standardized 100 Mbps high-speed
Ethernet LAN. It also allows attachment to existing 10 Mbps Ethernet LANs. The
Ethernet/IEEE 802.3 IOA is capable of operating in half or full duplex mode. The adapter
comes with an RJ-45 connector for attachment to UTP-5 media. Cabling for 10 Mbps must be
CAT-3 or CAT-5. Cabling for 100 Mbps must be CAT-5 that meets or exceeds Industry Standard
EIA/TIA T568A or T568B.
If the #2838/#9738 is selected to run on a #2866 Integrated Netfinity Server, then one #0222
(100/10 Mbps Ethernet on Integrated Netfinity Server) is required for each #2838/#9738
ordered.