IBM H5S, Руководство по установке, эксплуатации и обслуживанию

Страница: 60 / 149

Note: If you inserted an invalid tape cartridge (for example, Gen2 or WORM
media), error code
J
or
7
appears in the SCD. If you inserted a
write-protected cartridge, or the media has read-only compatibility (for
example, Gen3 media), error code
P
appears in the SCD. In either case,
the tape drive unloads the cartridge and exits Maintenance Mode after
the cartridge is removed.
Function Code 9: Display Error Code Log
Function Code
9
displays the last ten error codes, one at a time (the codes are
ordered; the most recent is presented first and the oldest is presented last). If there
are no errors in the log, function code
0
displays in the Single-character Display
(SCD) and exits Maintenance Mode.
1. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page 3-9.
2. Press the Unload Button once per second until
9
appears in the SCD. (If you
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press the Unload Button, then release it to view the most recent error code.
4. Press and release the Unload Button again to view successive error codes. Let
two to three seconds pass between each depression. The Ready light and Fault
light will flash On/Off once for each successive error code. The SCD will
display
0
when all the error codes have been displayed.
5. After viewing all error codes, exit this function by pressing the Unload Button
again. The SCD will display
0
and exit Maintenance Mode.
Function Code A: Clear Error Code Log
Function Code
A
erases the contents of the error code log.
1. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page 3-9.
2. Press the Unload Button once per second until
A
appears in the SCD. (If you
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press and hold the Unload Button for three or more seconds, then release it to
select the function.
A
flashes in the SCD, followed by
0
. The tape drive
erases all errors from the error code log and exits Maintenance Mode.
Function Code C: Insert Cartridge into Tape Drive
This function cannot be selected by itself, but is part of other maintenance
functions (such as Run Tape Drive Diagnostics and Create FMR Tape) that require
a tape cartridge to be inserted.
3-16
TS2250 Tape Drive Setup, Operator and Service manual